The skid control ECU (brake booster with master cylinder assembly) is connected to the combination meter assembly via CAN communication.
When replacing the skid control ECU (brake booster with master cylinder assembly), perform initialization and calibration of the linear solenoid valve.
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM>INITIALIZATION
Check if CAN communication system DTCs are output.
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>DIAGNOSIS SYSTEM
| Result | Proceed to |
|---|---|
| DTC is not output. | A |
| DTC is output. | B |
A
B
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
Disconnect the A28 skid control ECU (brake booster with master cylinder assembly) connector.
Turn the power switch on (IG).
Check that the brake warning light / red (malfunction) comes on.
The brake warning light / red (malfunction) comes on.
If troubleshooting has been carried out according to Problem Symptoms Table, refer back to the table and proceed to the next step before replacing the part.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Turn the power switch off.
Reconnect the A28 skid control ECU (brake booster with master cylinder assembly) connector.
Perform the Active Test of the combination meter assembly (meter CPU) using the intelligent tester.
Click hereVehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>DATA LIST / ACTIVE TEST
| Tester Display |
|---|
| Indicat. Lamp Brake |
Check the combination meter assembly.
The brake warning light / red (malfunction) turns on or off in accordance with intelligent tester operation.
If troubleshooting has been carried out according to Problem Symptoms Table, refer back to the table and proceed to the next step.
| Proceed to |
|---|
| OK |
| NG |
OK
NG