Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › BATTERY COOLING DUCT(w/ Filter) › 2012.02–2015.04
RM2040EQ _51 Engine / Hybrid System _014692 HYBRID / BATTERY CONTROL _0109199 BATTERY COOLING DUCT(w/ Filter) A

HYBRID / BATTERY CONTROL  BATTERY COOLING DUCT(w/ Filter)  INSTALLATION  


PROCEDURE

Hide 1.INSTALL NO. 1 HYBRID BATTERY INTAKE FILTER

a.
A318968

Install the No. 1 hybrid battery intake filter to the No. 1 hybrid battery intake duct.

NOTICE:
A308345C01
0.802,1.896 0.385,1.896 false 1.906,0.865 1.865,0.656 false 0.25,0.521 0.479,0.698 0.229,0.177 10 false *a 0.844,1.833 1.073,2.01 0.229,0.177 10 false *b 1.875,0.885 2.104,1.063 0.229,0.177 10 false *b
*a Cross Section View of No. 1 Hybrid Battery Intake Duct
*b Rubber Portion of No. 1 Hybrid Battery Intake Filter


Make sure the rubber portion of the No. 1 hybrid battery intake filter is behind the points shown in the illustration.



b.
A318969
2.188,1.875 2.604,1.385 true 2.646,0.885 2.344,0.75 true 3.146,1.104 2.896,1.354 true 2.073,1.906 2.292,2.083 0.219,0.177 10 false *1 2.188,0.667 2.406,0.844 0.219,0.177 10 false *1 3.167,1.021 3.385,1.198 0.219,0.177 10 false *1
*1 Tape


Apply 3 pieces of tape as shown in the illustration to secure the No. 1 hybrid battery intake filter to the No. 1 hybrid battery intake duct.

HINT:

If the adhesion of the tape is weak, replace it with new tape.



Hide 2.INSTALL REAR SIDE SEATBACK ASSEMBLY LH

Hide 72693 4.INSTALL REAR SEAT CUSHION LOCK HOOK

Hide 5.INSTALL REAR SEAT CUSHION ASSEMBLY