Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › STEERING PAD › from 2015.04
RM2040EQ _58 Vehicle Interior _014727 SUPPLEMENTAL RESTRAINT SYSTEMS _0075079 STEERING PAD A

SUPPLEMENTAL RESTRAINT SYSTEMS  STEERING PAD  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

CAUTION:

Be sure to read Precaution thoroughly before servicing (Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).


NOTICE:

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work (Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 64718C 2.REMOVE LUGGAGE TRIM SERVICE HOLE COVER

Hide 3.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 45187 4.REMOVE LOWER NO. 3 STEERING WHEEL COVER

a.
B369930C02
1.969,0.729 2.146,0.188 2.146,0.188 2.396,0.188 true 2.438,0.115 2.688,0.313 0.25,0.198 10 true *a
*a Protective Tape


Using a screwdriver with its tip wrapped with protective tape, disengage the claw and guide to remove the lower No. 3 steering wheel cover.


Hide 45186 5.REMOVE LOWER NO. 2 STEERING WHEEL COVER

a.
B369931C02
1.615,0.75 1.458,0.26 1.458,0.26 1.281,0.26 true 1.083,0.188 1.281,0.385 0.198,0.198 10 true *a
*a Protective Tape


Using a screwdriver with its tip wrapped with protective tape, disengage the claw and guide to remove the lower No. 2 steering wheel cover.


Hide 45130 6.REMOVE HORN BUTTON ASSEMBLY

CAUTION:

When storing the horn button assembly, keep the airbag deployment side facing upward.


a.

Check that the power switch is off.


b.

Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.



c.
B381123C02
0.365,0.469 0.625,0.469 true 2.583,2.635 2.844,2.635 true 0.677,2.615 0.677,2.958 true 0.604,2.969 0.823,3.135 0.219,0.167 10 true *a 2.885,2.563 3.104,2.729 0.219,0.167 10 true *a 0.188,0.385 0.385,0.552 0.198,0.167 10 true *a
*a Torsion Spring


Using a screwdriver, push in the 3 torsion springs to disengage the 3 pins as shown in the illustration.

NOTICE:

Do not drop the horn button assembly.


HINT:

Insert the screwdriver from the installation holes for the lower No. 3 steering wheel cover and lower No. 2 steering wheel cover.



d.

Pull out the horn button assembly from the steering wheel assembly and hold the horn button assembly with one hand.

NOTICE:

When separating the horn button assembly, do not pull the airbag wire harness.



e.
B381102C02
0.365,1.771 1.396,1.771 true 1.25,2.021 1.25,2.719 true 1.99,2.146 2.708,2.146 true 0.802,0.615 1.094,0.938 1.094,0.938 1.375,0.938 true 0.198,1.698 0.375,1.906 0.177,0.208 10 true *d 1.167,2.76 1.479,2.917 0.313,0.156 10 false *a 2.74,2.073 3.01,2.333 0.271,0.26 10 true *b 1.417,0.875 1.729,1.031 0.313,0.156 10 false *c
*a Airbag Connector
*b Horn Connector
*c Airbag Connector Lock
*d Protective Tape


Disconnect the horn connector from the horn button assembly.


f.

Using a screwdriver with its tip wrapped with protective tape, release the airbag connector lock.


g.

Disconnect the airbag connector to remove the horn button assembly.

NOTICE:

When disconnecting any airbag connector, take care not to damage the airbag wire harness.