Home › Vehicle Interior › SEAT › FRONT SEAT ASSEMBLY(for Manual Seat) › from 2015.04
RM2040EQ _58 Vehicle Interior _014728 SEAT _0075089 FRONT SEAT ASSEMBLY(for Manual Seat) A

SEAT  FRONT SEAT ASSEMBLY(for Manual Seat)  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

CAUTION:
·

Be sure to read precaution thoroughly before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION

·

If the side airbag was deployed, replace the front seat airbag assembly, front seatback frame sub-assembly, separate type front seatback pad and separate type front seatback cover with the necessary parts in accordance with the extent of the collision damage.



NOTICE:

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 64718C 2.REMOVE LUGGAGE TRIM SERVICE HOLE COVER

Hide 3.DISCONNECT CABLE FROM AUXILIARY BATTERY NEGATIVE TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 71910A 4.REMOVE FRONT SEAT HEADREST ASSEMBLY

Hide 72138J 5.REMOVE REAR OUTER SEAT TRACK BRACKET COVER

a.

Lift up the seat track adjusting handle and move the front seat assembly to the foremost position.


b.
B281488

Disengage the 2 claws to remove the rear outer seat track bracket cover.


Hide 72158 6.REMOVE REAR INNER SEAT TRACK BRACKET COVER

a.
B281489

Disengage the 2 claws to remove the rear inner seat track bracket cover.


Hide 7.REMOVE FRONT SEAT ASSEMBLY

a.
B286512

Remove the 2 bolts on the rear side of the front seat assembly.


b.

Lift up the seat track adjusting handle and move the front seat assembly to the rearmost position.


c.
B286511

Remove the 2 bolts on the front side of the front seat assembly.


d.

Disconnect each connector and clamp under the front seat assembly.


e.

Lift up the seat track adjusting handle and move the front seat assembly to the center position. Then, operate the reclining adjuster release handle and move the seatback to the upright position.


f.

Remove the front seat assembly.

NOTICE:

Be careful not to damage the vehicle body.