Home › Vehicle Interior › SEAT › FRONT SEAT ASSEMBLY(for Manual Seat) › from 2015.04
RM2040EQ _58 Vehicle Interior _014728 SEAT _0075089 FRONT SEAT ASSEMBLY(for Manual Seat) A

SEAT  FRONT SEAT ASSEMBLY(for Manual Seat)  INSTALLATION  


PROCEDURE

Hide 1.INSTALL FRONT SEAT ASSEMBLY

a.

Place the front seat assembly in the cabin.

NOTICE:

Be careful not to damage the vehicle body.



b.

Connect each connector and clamp under the front seat assembly.


c.

Temporarily install the front seat assembly with the 4 bolts.


d.

Lift up the seat track adjusting handle and move the front seat assembly to the rearmost position.


e.
B286511N02
2.813,1.563 3.01,1.76 0.198,0.198 10 true 1 2.354,1.958 2.563,2.135 0.208,0.177 10 true 2

Tighten the 2 bolts on the front side of the front seat assembly.

Torque:
37 N*m (377 kgf*cm, 27 ft.*lbf)

NOTICE:

Tighten the bolts in the order shown in the illustration.



f.

Lift up the seat track adjusting handle and move the front seat assembly to the foremost position.


g.
B286512N03
1.844,1.656 2.042,1.917 0.198,0.26 10 false 2 1.344,1.656 1.573,1.854 0.229,0.198 10 false 1

Tighten the 2 bolts on the rear side of the front seat assembly.

Torque:
37 N*m (377 kgf*cm, 27 ft.*lbf)

NOTICE:

Tighten the bolts in the order shown in the illustration.



Hide 2.INSPECT SEAT SLIDE ADJUSTER LOCKS

a.

During the sliding operation of the front seat assembly, check that the left and right adjusters move together smoothly and lock simultaneously. If the seat adjusters do not lock simultaneously, loosen the front seat assembly installation bolts to adjust the adjuster position.


Hide 72158 3.INSTALL REAR INNER SEAT TRACK BRACKET COVER

a.

Lift up the seat track adjusting handle and move the front seat assembly to the foremost position.


b.

Engage the 2 claws to install the rear inner seat track bracket cover.


Hide 72138J 4.INSTALL REAR OUTER SEAT TRACK BRACKET COVER

a.

Engage the 2 claws to install the rear outer seat track bracket cover.


Hide 71910A 5.INSTALL FRONT SEAT HEADREST ASSEMBLY

Hide 6.CONNECT CABLE TO AUXILIARY BATTERY NEGATIVE TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 64718C 7.INSTALL LUGGAGE TRIM SERVICE HOLE COVER