Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › REAR DOOR BELT MOULDING › from 2015.04
RM2040EQ _59 Vehicle Exterior _014740 EXTERIOR PANELS / TRIM _0075194 REAR DOOR BELT MOULDING A

EXTERIOR PANELS / TRIM  REAR DOOR BELT MOULDING  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.REMOVE LUGGAGE TRIM SERVICE HOLE COVER

Hide 3.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 69284D 4.REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG

Hide 5.REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL

Hide 74260 6.REMOVE REAR ARMREST ASSEMBLY

Hide 67604 7.REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY

Hide 68174A 8.REMOVE REAR DOOR INNER GLASS WEATHERSTRIP

Hide 67842E 9.REMOVE REAR DOOR SERVICE HOLE COVER

Hide 68640A 10.REMOVE REAR DOOR CHECK ASSEMBLY

Hide 67872 11.REMOVE REAR DOOR WEATHERSTRIP

Hide 68152C 12.REMOVE REAR DOOR GLASS RUN

Hide 67408F 13.REMOVE REAR DOOR LOWER WINDOW FRAME SUB-ASSEMBLY

Hide 68124B 14.REMOVE REAR DOOR QUARTER WINDOW GLASS

Hide 68104 15.REMOVE REAR DOOR GLASS SUB-ASSEMBLY

Hide 75740 16.REMOVE REAR DOOR BELT MOULDING ASSEMBLY

a.
B380984C01
0,0 0,0 false
V100155

Protective Tape


Apply protective tape around the rear door belt moulding assembly as shown in the illustration.


b.
B380985C01
2.021,0.854 1.823,0.854 false 2.052,0.771 2.354,1.031 0.302,0.26 10 false *a
*a Screwdriver
V100155

Protective Tape


Using a screwdriver with its tip wrapped with protective tape, disengage the 6 claws as shown in the illustration and remove the rear door belt moulding assembly.