Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
1. PRECAUTION
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.REMOVE LUGGAGE TRIM SERVICE HOLE COVER
3.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
69284D
4.REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG
5.REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL
74260
6.REMOVE REAR ARMREST ASSEMBLY
67604
7.REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY
68174A
8.REMOVE REAR DOOR INNER GLASS WEATHERSTRIP
67842E
9.REMOVE REAR DOOR SERVICE HOLE COVER
68640A
10.REMOVE REAR DOOR CHECK ASSEMBLY
67872
11.REMOVE REAR DOOR WEATHERSTRIP
68152C
12.REMOVE REAR DOOR GLASS RUN
67408F
13.REMOVE REAR DOOR LOWER WINDOW FRAME SUB-ASSEMBLY
68124B
14.REMOVE REAR DOOR QUARTER WINDOW GLASS
68104
15.REMOVE REAR DOOR GLASS SUB-ASSEMBLY
67674A
16.REMOVE REAR DOOR FRAME GARNISH
17.REMOVE NO. 2 BLACK OUT TAPE
Using a heat light, heat the No. 2 black out tape and vehicle body.
| Item | Temperature |
|---|---|
| Vehicle Body and No. 2 Black Out Tape | 40 to 60°C (104 to 140°F) |
Do not heat the vehicle body excessively.
Pull back on one of the ends of the No. 2 black out tape to remove it.
When pulling on the No. 2 black out tape, pull it parallel to the body.
75988C
18.REMOVE REAR DOOR OUTSIDE STRIPE
Using a heat light, heat the rear door outside stripe and vehicle body.
| Item | Temperature |
|---|---|
| Vehicle Body and Rear Door Outside Stripe | 40 to 60°C (104 to 140°F) |
Do not heat the vehicle body excessively.
Pull back on one of the ends of the rear door outside stripe to remove it.
When pulling on the stripe, pull it parallel to the body.
75978H
19.REMOVE REAR DOOR LOWER OUTSIDE STRIPE
Using a heat light, heat the rear door lower outside stripe and vehicle body.
| Item | Temperature |
|---|---|
| Vehicle Body and Rear Door Lower Outside Stripe | 40 to 60°C (104 to 140°F) |
Do not heat the vehicle body excessively.
Pull back on one of the ends of the rear door lower outside stripe to remove it.
When pulling on the stripe, pull it parallel to the body.