1. PRECAUTION
Perform the Vehicle Identification Number (VIN) registration when replacing the ECM.
Click hereEngine / Hybrid System>2AR-FXE ENGINE CONTROL>SFI SYSTEM>REGISTRATION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
64718C
2.REMOVE LUGGAGE TRIM SERVICE HOLE COVER
3.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
89661
4.REMOVE ECM
Disconnect the 2 ECM connectors.
Push in the locks on the 2 levers, raise the levers, and disconnect the 2 ECM connectors.
After disconnecting the connectors, make sure that dirt, water or other foreign matter does not contact the connecting part of the connectors.
Remove the nut.
Remove the screw (A).
Loosen the screw (B) and remove the ECM.
Remove the screw (B).
Remove the 2 screws and No. 2 ECM bracket.
82662A
5.REMOVE NO. 1 RELAY BLOCK COVER
89667E
6.REMOVE NO. 1 ECM BRACKET
Remove the nut.
Release the 2 clamps and disconnect the wire harness.
Disconnect the wire harness clamp.
Remove the nut and No. 1 ECM bracket.