DTC P2610 ECM / PCM Internal Engine Off Timer Performance |

| Required Sensors/Components | ECM |
| Frequency of Operation | Once per driving cycle |
| Tester Display | Description |
| NORMAL |
|
| ABNORMAL |
|
| INCOMPLETE |
|
| N/A |
|
| 1.REPLACE ECM |
Replace the ECM (Click here).
| NEXT | |
| 2.CHECK WHETHER DTC OUTPUT RECURS (DTC P2610) |
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Turn the tester on.
Clear the DTCs (Click here).
Turn the power switch off and wait for at least 30 seconds.
Turn the power switch on (IG).
Turn the tester on.
Put the engine in inspection mode (maintenance mode) (Click here).
Start the engine and wait for 10 minutes or more.
Enter the following menus: Powertrain / Engine and ECT / DTC / Pending.
If no pending DTC is output, the repair has been successfully completed.
| NEXT | ||
| ||