DTC P0560 System Voltage |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0560 | An open in the ECM back up power source circuit (1 trip detection logic). |
|
| Required Sensors/Components | ECM |
| Frequency of Operation | Continuous |
| Both of the following conditions are met | - |
| Auxiliary battery voltage | Less than 3.5 V |
| Stand-by RAM | Initialized |
| Tester Display | Description |
| NORMAL |
|
| ABNORMAL |
|
| INCOMPLETE |
|
| N/A |
|

| 1.INSPECT AUXILIARY BATTERY |
Inspect that the auxiliary battery is not depleted (Click here).
|
| ||||
| OK | |
| 2.CHECK AUXILIARY BATTERY TERMINAL |
Check that the auxiliary battery terminals are not loose or corroded.
|
| ||||
| OK | |
| 3.CHECK TERMINAL VOLTAGE (POWER SOURCE OF ECM) |
![]() |
Disconnect the ECM connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A25-1 (BATT) - Body ground | Always | 11 to 14 V |
| *a | Front view of wire harness connector (to ECM) |
|
| ||||
| OK | |
| 4.CHECK WHETHER DTC OUTPUT RECURS (DTC P0560) |
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Turn the tester on.
Clear the DTCs (Click here).
Turn the power switch off and wait for at least 30 seconds.
Turn the power switch on (IG).
Turn the tester on.
Wait 5 seconds or more.
Enter the following menus: Powertrain / Engine and ECT / DTC.
Read the DTCs.
| Result | Proceed to |
| DTC P0560 is output | A |
| DTC is not output | B |
|
| ||||
| A | ||
| ||