ELECTRONICALLY CONTROLLED BRAKE SYSTEM > TS and CG Terminal Circuit |

| 1.CHECK CAN COMMUNICATION SYSTEM |
Check if CAN communication system DTCs are output (Click here).
| Result | Proceed to |
| DTC is not output. | A |
| DTC is output. | B |
|
| ||||
| A | |
| 2.INSPECT DLC3 |
![]() |
Turn the power switch on (IG).
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I39-12 (TS) - I39-4 (CG) | Power switch on (IG) | 11 to 14 V |
| *a | Front view of DLC3 |
|
| ||||
| OK | |
| 3.CHECK POWER STEERING ECU ASSEMBLY (TS of DLC3 INPUT) |
![]() |
Turn the power switch off.
Using SST, connect terminals TS and CG of the DLC3.
Check that the P/S warning light is blinking.
| *a | Front view of DLC3 |
| Result | Proceed to |
| OK (for LHD) | A |
| OK (for RHD) | B |
| NG | C |
|
| ||||
|
| ||||
| A | ||
| ||
| 4.CHECK HARNESS AND CONNECTOR (TS of DLC3 - POWER STEERING ECU ASSEMBLY) |
Turn the power switch off.
Disconnect the power steering ECU assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I39-12 (TS) - j3-5 (TS) | Always | Below 1 Ω |
| I39-12 (TS) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 5.CHECK HARNESS AND CONNECTOR (CG of DLC3 - BODY GROUND) |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I39-4 (CG) - Body ground | Always | Below 1 Ω |
| *a | Front view of DLC3 |
|
| ||||
| OK | |
| 6.CHECK POWER STEERING ECU ASSEMBLY (TS of DLC3 INPUT) |
![]() |
Reconnect the power steering ECU assembly connector.
Using SST, connect terminals TS and CG of the DLC3.
Check that the P/S warning light is blinking.
| *a | Front view of DLC3 |
| Result | Proceed to |
| OK (for LHD) | A |
| OK (for RHD) | B |
| NG | C |
|
| ||||
|
| ||||
| A | ||
| ||