METER / GAUGE SYSTEM > Engine Coolant Temperature Receiver Gauge Malfunction |

| 1.CHECK CAN COMMUNICATION SYSTEM |
Check if CAN communication DTCs are output (Click here).
| Result | Proceed to |
| DTCs are not output. | A |
| DTCs are output. | B |
|
| ||||
| A | |
| 2.PERFORM ACTIVE TEST USING INTELLIGENT TESTER (WATER TEMPERATURE METER OPERATION) |
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Body / Combination Meter / Active Test.
Check the operation by referring to the table below.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Water Temperature Meter Operation | Engine coolant temperature receiver gauge | Low, Normal, High | - |
|
| ||||
| OK | |
| 3.CHECK SFI SYSTEM |
Check if SFI system DTCs are output (Click here w/o EGR System, Click here w/ EGR System).
| Result | Proceed to |
| DTCs are output. | A |
| DTCs are output (w/o EGR System). | B |
| DTCs are output (w/ EGR System). | C |
|
| ||||
|
| ||||
| A | |
| 4.READ VALUE USING INTELLIGENT TESTER (COOLANT TEMP, COOLANT TEMPERATURE) |
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Turn the intelligent tester on.
Enter the following menus:
for Engine and ECT: Powertrain / Engine and ECT / Data List.
for Combination Meter: Body / Combination Meter / Data List.
Check the values by referring to the table below.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Coolant Temp | Coolant temperature/Min.: -40°C (-40°F), Max.: 140°C (284°F) | 75 to 100°C (167 to 212°F): After warming up |
|
| |||
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Coolant Temperature | Engine coolant temperature/-40 to 140°C (-40 to 284°F) | After warming up: 80 to 95°C (176 to 203°F) |
|
| Result | Proceed to |
| The data list values of the ECUs match. | A |
| The data list values of the ECUs do not match. | B |
|
| ||||
| A | ||
| ||