Home › Steering › STEERING COLUMN › STEERING LOCK SYSTEM

DTC    B2781    Open / Short in Steering Lock ECU

for Preparation Click here


DESCRIPTION

The steering lock ECU and steering lock motor are built into the steering lock actuator assembly.
The steering lock ECU detects whether the steering lock is in the lock or unlock position by using the lock position sensor of the steering lock motor.
The steering lock ECU receives lock and unlock request signals from the certification ECU (smart key ECU assembly) and responds with lock and unlock operation signals.

HINT:
The steering lock ECU is not connected to the CAN communication system. However, the steering lock ECU is connected to the certification ECU (smart key ECU assembly) via LIN communication and communicates with other components via CAN communication through the certification ECU (smart key ECU assembly).


DTC No.
Detection Condition
Trouble Area
DTC Output Confirmation Operation
B2781
One of the following conditions is met (1-trip detection logic*1):
  1. The steering lock/unlock position sensor is malfunctioning.*2
  2. The steering lock motor activation circuit has a short circuit.
  3. The steering lock motor activation circuit has an open circuit.
  1. Steering lock ECU (Steering lock actuator assembly)
  2. LIN communication system
No confirmation operation is necessary (monitoring is continuous).
  1. *1: Only output while a malfunction is present and the power switch is on (IG).
  2. *2: When both detection switches turn on, the system is determined to be malfunctioning.

C221981E01


Vehicle Condition and Fail-safe Function when Malfunction Detected 
Vehicle Condition when Malfunction Detected
Fail-safe Function when Malfunction Detected
The steering cannot be locked or unlocked. For this reason, the hybrid control system cannot be started.
Prohibits the hybrid control system from being started.

Related Data List and Active Test Items 
DTC No.
Data List Item
Active Test Item
B2781
Entry&Start
  1. Sensor Value
  2. Motor Driver Short
-

INSPECTION PROCEDURE

NOTICE:
  1. When using the intelligent tester with the power switch off, perform either of the following: 1) Turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the intelligent tester and vehicle begins, or 2) connect the intelligent tester to the vehicle and select "Manual" from the initial screen on the intelligent tester. Select "Key Code Registration" under model code.
  2. After performing repairs, confirm that no DTCs are output again (Click here).
  3. When replacing the steering lock ECU (steering lock actuator assembly), registration must be performed (refer to Service Bulletin).

HINT:
When all the ECUs that are connected to the LIN communication cannot communicate with the certification ECU (smart key ECU assembly), DTC B2785 is stored.

1.CHECK DTC
  1. Using the intelligent tester, check if LIN communication DTC B2785 is output (Click here).

    HINT:
    If a LIN communication DTC is output, perform troubleshooting for the LIN communication system (Click here).


    Result:

    Result
    Proceed to
    DTC B2785 is output.
    A
    DTC B2785 is not output.
    B



B
REPLACE STEERING LOCK ACTUATOR ASSEMBLY (Click here)
A

GO TO LIN COMMUNICATION SYSTEM (DTC B2785) (Click here)