Home › Power Source / Network › NETWORKING › LIN COMMUNICATION SYSTEM

DTC    B2785    Communication Malfunction between ECUs Connected by LIN

for Preparation Click here


DESCRIPTION

The certification ECU (smart key ECU assembly) monitors communication between all the ECUs connected to the certification bus lines. When the certification ECU (smart key ECU assembly) detects errors in communication with all the ECUs connected to the certification bus lines at a set interval and 3 times in a row, DTC B2785 will be stored.

DTC No.
DTC Detection Condition
Trouble Area
B2785
  1. Errors in LIN communication between ECUs or an open or short in communication lines
  2. LIN communication from the certification ECU (smart key ECU assembly) detects errors in communication 3 times in a row.
  1. Certification ECU (smart key ECU assembly)
  2. Steering lock ECU (steering lock actuator assembly)
  3. Power management control ECU
  4. Wire harness or connector

WIRING DIAGRAM


B281971E07


INSPECTION PROCEDURE

NOTICE:
  1. If the certification ECU (smart key ECU assembly) is replaced, register the keys (refer to the Service Bulletin).
  2. If the steering lock ECU (steering lock actuator assembly) is replaced, register the ECU code (refer to the Service Bulletin).
  3. When using the intelligent tester to troubleshoot with the power switch off:
    Connect the intelligent tester to the DLC3, and turn the courtesy switch on and off at 1.5-second intervals until communication between the intelligent tester and vehicle begins.

1.CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - EACH ECU)
  1. Disconnect the I87certification ECU (smart key ECU assembly) connector.

  1. Disconnect the I4 power management control ECU connector.

  1. Disconnect the I24 steering lock ECU (steering lock actuator assembly) connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    I87-12 (LIN) - I24-5 (LIN)
    Always
    Below 1 Ω
    I87-12 (LIN) - I4-11 (LIN2)
    Always
    Below 1 Ω
    I87-12 (LIN) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.CHECK DTC OUTPUT (STEERING LOCK ECU)
  1. Reconnect the I87certification ECU (smart key ECU assembly) connector.

  1. Reconnect the I4 power management control ECU connector.

  1. Clear the DTC (Click here).

  1. Recheck for DTCs.

    Result:
    Result
    Proceed to
    DTC B2785 is output
    A
    DTC B2785 is not output
    B



B
REPLACE STEERING LOCK ECU (STEERING LOCK ACTUATOR ASSEMBLY) (Click here)
A


3.CHECK DTC OUTPUT (POWER MANAGEMENT CONTROL ECU)
  1. Reconnect the I24 steering lock ECU (steering lock actuator assembly) connector.

  1. Disconnect the I4 power management control ECU connector.

  1. Clear the DTC (Click here).

  1. Recheck for DTCs.

    Result:
    Result
    Proceed to
    DTC B2785 is output
    A
    DTC B2785 is not output
    B



B
REPLACE POWER MANAGEMENT CONTROL ECU (Click here)
A

REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)