Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM

DTC    C1521/25    Short in Motor Circuit

DTC    C1531/25    ECU Malfunction

DTC    C1532/25    ECU Malfunction

DTC    C1533/25    Temperature Sensor Circuit is Low or High

DTC    C1534/25    EEPROM Malfunction

for Preparation Click here


DESCRIPTION

If the power steering ECU assembly stores these DTCs, it will shut off the motor relay circuit (built into the power steering ECU assembly) and stop power assist. However, power assist continues if DTC C1533/25 or C1534/25 is output.

DTC No.
DTC Detection Condition
Trouble Area
C1521/25
Motor overcurrent
Power steering ECU assembly
C1531/25
ECU internal malfunction (CPU malfunction)
C1532/25
ECU internal malfunction (Peripheral circuit malfunction)
C1533/25
ECU internal malfunction (Substrate temperature sensor malfunction)
C1534/25
ECU internal malfunction (EEPROM error)

INSPECTION PROCEDURE

NOTICE:
If the power steering ECU assembly has been replaced, perform assist map writing (Click here).

1.CHECK FOR DTC
  1. Clear the DTCs (Click here).

  1. Check for DTCs (Click here).


Result:

Result
Proceed to
DTCs (except C1521/25, C1531/25, C1532/25, C1533/25 and C1534/25 DTC) are not output
A
DTCs (except C1521/25, C1531/25, C1532/25, C1533/25 and C1534/25 DTC) are output
B



B
REPAIR CIRCUITS INDICATED BY OUTPUT DTCS (Click here)
A

REPLACE POWER STEERING ECU ASSEMBLY (Click here)