Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM

DTC    C1528/12    Motor Rotation Angle Sensor Malfunction

for Preparation Click here


DESCRIPTION

The motor rotation angle sensor detects the motor rotation angle and sends this information to the power steering ECU assembly.

DTC No.
DTC Detection Condition
Trouble Area
C1528/12
Motor rotation angle sensor malfunction
  1. Power steering motor assembly (Motor rotation angle sensor)
  2. Power steering ECU assembly

WIRING DIAGRAM


C240263E02


INSPECTION PROCEDURE

NOTICE:
If the power steering ECU assembly has been replaced, perform assist map writing (Click here).

1.CHECK CONNECTOR CONNECTION CONDITION
  1. Check the connection condition of the motor rotation angle sensor connector.

    OK:
    Motor rotation angle sensor connector is securely connected to the power steering ECU assembly.



NG
CONNECT CONNECTOR
OK


2.READ VALUE USING INTELLIGENT TESTER (MOTOR ROTATION ANGLE SENSOR)
  1. Turn the power switch off.

  1. Connect the intelligent tester to the DLC3.

  1. Turn the power switch on (READY).

  1. Turn the intelligent tester on.

  1. Enter the following menus: Chassis / EMPS / Data List.

  1. Select the item "Motor Rotation Angle" in the Data List and read the value displayed on the intelligent tester.

    EMPS 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Motor Rotation Angle
    Motor rotation angle/
    Min.: 0.000 deg
    Max.: 1441.770 deg
    During steering operation, motor rotation angle value changes from 0 to 360°
    Power switch on (READY) and steering wheel being turned

    OK:
    During steering operation, motor rotation angle value changes from 0 to 360°.



NG
Go to step 3
OK

REPLACE POWER STEERING ECU ASSEMBLY (Click here)  

3.CHECK POWER STEERING MOTOR ASSEMBLY (MOTOR ROTATION ANGLE SENSOR)


    C238938E02
  1. Disconnect the connector from the motor rotation angle sensor.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    b-6 (RZV1) - b-2 (RZV2)
    25°C (77°F)
    14.0 to 17.2 Ω
    b-5 (RZCS1) - b-1 (RZCS2)
    25°C (77°F)
    25.8 to 31.6 Ω
    b-7 (RZSN1) - b-3 (RZSN2)
    25°C (77°F)
    25.8 to 31.6 Ω

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Motor Rotation Angle Sensor)



NG
REPLACE POWER STEERING MOTOR ASSEMBLY (Click here)
OK

REPLACE POWER STEERING ECU ASSEMBLY (Click here)