Home › Vehicle Interior › LIGHTING (INT) › LIGHTING SYSTEM

LIGHTING SYSTEM > Power Switch Illumination Circuit

for Preparation Click here


DESCRIPTION

The illuminated entry system controls the power switch illumination.

WIRING DIAGRAM


E237082E02


INSPECTION PROCEDURE

1.PERFORM ACTIVE TEST USING INTELLIGENT TESTER
  1. Connect the intelligent tester to the DLC3.

  1. Turn the power switch on (IG).

  1. Turn the intelligent tester on.

  1. Enter the following menus: Body / Entry&Start / Active Test.

  1. Check that the illumination operates.

    Entry&Start 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Power/Engine SW Light
    Power switch light
    OFF/ON
    When performing this Active Test, make sure the following condition is met:
    The power switch illumination is off (15 seconds or more have elapsed since it turned from on to off) and the power switch is on (ACC) or on (IG), or the hybrid control system is running.

    OK:
    Power switch illumination comes on.



NG
Go to step 2
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)  

2.INSPECT POWER SWITCH
  1. Remove the power switch (Click here).

  1. Inspect the power switch (Click here).

    OK:
    Power switch illumination comes on.



NG
REPLACE POWER SWITCH (Click here)
OK


3.CHECK HARNESS AND CONNECTOR (POWER SWITCH - CERTIFICATION ECU (SMART KEY ECU ASSEMBLY))
  1. Disconnect the I87 and I86 certification ECU (smart key ECU assembly) connector.

  1. Disconnect the I58 power switch connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    I58-9 (SWIL) - I87-6 (SWIL)
    Always
    Below 1 Ω
    I58-6 (AGND) - I86-6 (AGND)
    Always
    Below 1 Ω
    I58-9 (SWIL) - Body ground
    Always
    10 kΩ or higher
    I58-6 (AGND) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)