Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › TOYOTA PARKING ASSIST-SENSOR SYSTEM

DTC    C1AE1    Front Left Sensor Malfunction

for Preparation Click here


DESCRIPTION

The No. 1 ultrasonic sensor (front left sensor) is installed on the front bumper. The ECU detects obstacles based on signals received from the No. 1 ultrasonic sensor (front left sensor). If the No. 1 ultrasonic sensor (front left sensor) has an open circuit or other malfunction, it will not function normally.

DTC No.
DTC Detection Condition
Trouble Area
C1AE1
A malfunction of the No. 1 ultrasonic sensor (front left sensor).
  1. No. 1 ultrasonic sensor (front left sensor)
  2. Clearance warning ECU assembly

INSPECTION PROCEDURE

NOTICE:
If DTCs are output after repairs, turn the power switch on (IG) and turn the clearance sonar main switch on. Then clear the DTCs (Click here).

1.CHECK DTC OUTPUT
  1. Check for DTCs (Click here).

    Result:
    Result
    Proceed to
    Only DTC C1AE1 is output
    A
    DTC C1AE1 and C1AEC are output
    B
    No DTCs are output
    C



B
GO TO DTC (C1AEC) (Click here)

C
USE SIMULATION METHOD TO CHECK (Click here)
A


2.REPLACE NO. 1 ULTRASONIC SENSOR (FRONT LEFT SENSOR)
  1. Replace the No. 1 ultrasonic sensor (front left sensor) with a known good one (Click here).

    HINT:
    All of the sensors are interchangeable. To confirm whether a sensor is functioning normally, switch it with a known good sensor from the other end of the vehicle.


NEXT


3.CHECK DTC OUTPUT
  1. Clear the DTCs (Click here).

  1. Check for DTCs (Click here).

    Result:
    Result
    Proceed to
    No DTCs are output
    OK
    DTC C1AE1 is output
    NG



NG
REPLACE CLEARANCE WARNING ECU ASSEMBLY (Click here)
OK

END (FRONT LEFT SENSOR WAS DEFECTIVE)