POWER STEERING ECU > INSTALLATION |
| 1. INSTALL POWER STEERING ECU ASSEMBLY |
Install the power steering ECU assembly to the power steering motor assembly with 2 new bolts.
Install 3 new bolts.
Engage the 4 claws to install a new protector.
| 2. INSTALL POWER STEERING ECU WITH MOTOR ASSEMBLY |
![]() |
Install the 2 service nuts to the steering main shaft.
| *1 | Service Nut |
Simultaneously to rotate the service nut that was installed first counterclockwise and rotate the service nut that was installed second clockwise to lock them.
Install a new O-ring to the power steering ECU with motor assembly.
![]() |
Apply grease to the splines of the power steering ECU with motor assembly.
Insert the power steering ECU with motor assembly into the splines of the electric power steering column sub-assembly.
![]() |
Secure the steering column assembly in a vice using aluminum plates and wooden block as shown in the illustration.
| *1 | Aluminum Plate |
| *2 | Wooden Block |
![]() |
Temporarily install the power steering ECU with motor assembly to the electric power steering column sub-assembly with 2 new bolts while rotating the steering main shaft at approximately 4 rpm.
Rotate the steering main shaft 120 to 240 degrees at approximately 4 rpm.
Rotate the steering main shaft 180 degrees clockwise and counterclockwise at approximately 4 rpm and repeat this operation 2 or 3 times to align the power steering ECU with motor assembly.
Tighten the 2 bolts.
![]() |
Measure the turning torque of the steering main shaft.
Remove the 2 service nuts from the steering main shaft.
Connect the 2 connectors to the power steering ECU with motor assembly.
| 3. CONNECT ECU WIRE SUB-ASSEMBLY |
Connect the 2 connectors to the power steering ECU assembly.
| 4. INSTALL POWER STEERING ECU PROTECTOR |
Engage the 2 claws to install a new power steering ECU protector to the power steering ECU with motor assembly.
| 5. INSTALL STEERING LOCK ACTUATOR ASSEMBLY |
Secure the steering column assembly in a vise.
![]() |
Temporarily install the steering lock actuator assembly to the steering column assembly with 2 new tapered-head bolts.
Tighten the 2 tapered-head bolts until the bolt heads break off.
| 6. INSTALL STEERING COLUMN ASSEMBLY |
| 7. ASSIST MAP WRITING |