Home › General › INTRODUCTION › REPAIR INSTRUCTION

REPAIR INSTRUCTION > INITIALIZATION



PROCEDURES NECESSARY WHEN ECU OR OTHER PARTS ARE REPLACED

Replacement Part
Necessary Procedure
Effect/Inoperative Function when Necessary Procedures are not Performed
See page
  1. Throttle with motor body assembly
  2. Cleaning the deposits from the throttle with motor body assembly
  3. Engine assembly
  4. Cylinder head sub-assembly
  5. Camshaft
    (for intake or exhaust camshaft)
  6. Camshaft timing gear assembly
  7. Piston or piston ring
  8. Mass air flow meter sub-assembly
  9. Fuel injector assembly
  10. Fuel pump
  11. Air fuel ratio sensor
  12. Engine coolant temperature sensor
  13. Spark plug
  14. Ignition coil assembly
  15. Air leaks from intake system
  16. Gas leaks from exhaust system
  17. Knock control sensor
Inspection after repair
Poor idle, engine starting, etc
Click here
Brake booster with master cylinder assembly
  1. Initialization and calibration of the linear solenoid valve
  2. Yaw rate and acceleration sensor zero point calibration
  1. ABS warning light illumination
  2. Brake warning light/yellow (minor malfunction) illumination
  3. Slip indicator light illumination
  4. VSC disable or malfunctioning
Click here for Initialization
Click here for Calibration
  1. Brake pedal stroke sensor assembly
  2. Brake pedal
  1. Clearing stored linear solenoid valve calibration data
  2. Initialization and calibration of the linear solenoid valve
Click here
  1. Yaw rate and acceleration sensor (for separate type)
  2. Yaw rate and acceleration sensor (Airbag sensor assembly) (for built-in type)
  1. Clearing zero point calibration data
  2. Yaw rate and acceleration sensor zero point calibration
Click here
Power steering ECU assembly
Assist map writing
  1. P/S warning light comes on
  2. EPS control
Click here
Power management control ECU
Code registration (Engine immobiliser system)
Hybrid control system start
See the Service Bulletin for the registration method.
  1. Certification ECU (smart key ECU assembly)
  2. Steering lock ECU (steering lock actuator assembly)
  3. Electrical key transmitter (key)
Code registration (Engine immobiliser system)
  1. Wireless door lock control system
  2. Smart entry and start system
  3. Hybrid control system start
  4. Steering lock system
See the Service Bulletin for the registration method.
  1. No. 1 air conditioning radiator damper servo sub-assembly
  2. No. 2 air conditioning radiator damper servo sub-assembly
  3. No. 1 blower damper servo sub-assembly
Initialization servo motor (Air conditioning system)
DTCs are output
Click here
  1. Door window regulator assembly
  2. Power window regulator motor assembly
  3. Door glass
  4. Door glass run
Initialize power window control system
  1. Auto up/down function
  2. Jam protection function
  3. Operation function after power switch is turned off
  4. Key-linked function
  5. Wireless transmitter-linked function
Click here
  1. Sliding roof ECU (sliding roof drive gear sub-assembly)
  2. Sliding roof glass sub-assembly
  3. Sliding roof drive cable sub-assembly
Initialize sliding roof ECU (pulse sensor initial position setting)
  1. Automatic slide open/close and tilt up/down function of sliding roof
  2. Jam protection function
  3. Operation function after power switch is turned off
  4. Key-linked function
  5. Wireless transmitter-linked function
  6. Sliding roof open warning
Click here
  1. Headlight leveling ECU assembly
  2. Rear height control sensor sub-assembly
Perform Headlight leveling ECU initialization
Automatic headlight beam level control function
Click here