Replacement Part
| Necessary Procedure
| Effect/Inoperative Function when Necessary Procedures are not Performed
| See page
|
- Throttle with motor body assembly
- Cleaning the deposits from the throttle with motor body assembly
- Engine assembly
- Cylinder head sub-assembly
- Camshaft
(for intake or exhaust camshaft)
- Camshaft timing gear assembly
- Piston or piston ring
- Mass air flow meter sub-assembly
- Fuel injector assembly
- Fuel pump
- Air fuel ratio sensor
- Engine coolant temperature sensor
- Spark plug
- Ignition coil assembly
- Air leaks from intake system
- Gas leaks from exhaust system
- Knock control sensor
- EGR valve assembly*1
| Inspection after repair
| - Poor idle, etc.
- Engine start function, etc
|
Click here w/ EGR System
Click here w/o EGR System
|
Brake booster with master cylinder assembly
| - Initialization and calibration of the linear solenoid valve
- Yaw rate and acceleration sensor zero point calibration
| - ABS warning light illumination
- Brake warning light/yellow (minor malfunction) illumination
- Slip indicator light illumination
- VSC disable or malfunctioning
|
Click here for Initialization
Click here for Calibration
|
- Brake pedal stroke sensor assembly
- Brake pedal
| - Clearing stored linear solenoid valve calibration data
- Initialization and calibration of the linear solenoid valve
|
Click here
|
Yaw rate and acceleration sensor (Airbag sensor assembly)
| - Clearing zero point calibration data
- Yaw rate and acceleration sensor zero point calibration
|
Click here
|
Power steering ECU assembly
| Assist map writing
| - P/S warning light comes on
- EPS control
|
Click here
|
Power management control ECU
| Code registration (Engine immobiliser system)
| Hybrid control system start
| See the Service Bulletin for the registration method.
|
- Certification ECU (smart key ECU assembly)
- Steering lock ECU (steering lock actuator assembly)
- Electrical key transmitter (key)
| Code registration (Engine immobiliser system)
| - Wireless door lock control system
- Smart entry and start system
- Hybrid control system start
- Steering lock system
| See the Service Bulletin for the registration method.
|
- No. 1 air conditioning radiator damper servo sub-assembly
- No. 2 air conditioning radiator damper servo sub-assembly
- No. 1 blower damper servo sub-assembly
| Initialization servo motor (Air conditioning system)
| DTCs are output
|
Click here
|
- Door window regulator assembly
- Power window regulator motor assembly
- Door glass
- Door glass run
| Initialize power window control system
| - Auto up/down function
- Jam protection function
- Operation function after power switch is turned off
- Key-linked function
- Wireless transmitter-linked function
|
Click here
|
- Sliding roof ECU (sliding roof drive gear sub-assembly)
- Sliding roof glass sub-assembly
- Sliding roof drive cable sub-assembly
| Initialize sliding roof ECU (pulse sensor initial position setting)
| - Automatic slide open/close and tilt up/down function of sliding roof
- Jam protection function
- Operation function after power switch is turned off
- Key-linked function
- Wireless transmitter-linked function
- Sliding roof open warning
|
Click here
|
- Headlight leveling ECU assembly
- Rear height control sensor sub-assembly
- Suspension, tire, etc.
| Perform headlight leveling ECU initialization
| Automatic headlight beam level control function
|
Click here
|