TOYOTA PARKING ASSIST-SENSOR SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING |
| 1.VEHICLE BROUGHT TO WORKSHOP |
| |||||
| 2.CUSTOMER PROBLEM ANALYSIS |
| |||||
| 3.INSPECT BATTERY VOLTAGE |
Measure the battery voltage.
| |||||
| 4.CHECK CAN COMMUNICATION SYSTEM* |
Use the intelligent tester to check if the CAN communication system is functioning normally (Click here).
| Result | Proceed to |
| CAN communication system DTCs are not output | A |
| CAN communication system DTCs are output | B |
|
| ||||
| |||||
| 5.PROBLEM SYMPTOM CONFIRMATION |
| |||||
| 6.CHECK DTC* |
Check for DTCs (Click here).
| Result | Proceed to |
| DTCs are output | A |
| DTCs are not output (Problem symptom does not occur) | B |
| DTCs are not output (Problem symptom occurs) | C |
|
| ||||
|
| ||||
| |||||
| 7.DIAGNOSTIC TROUBLE CODE CHART |
Refer to Diagnostic Trouble Code Chart (Click here).
|
| ||||
|---|---|---|---|---|---|
| 8.SYMPTOM SIMULATION |
Refer to Symptom Simulation (Click here).
| |||||
| 9.PROBLEM SYMPTOMS TABLE |
Refer to Problem Symptoms Table (Click here).
| Result | Proceed to |
| Fault is not listed in Problem Symptoms Table | A |
| Fault is listed in Problem Symptoms Table | B |
|
| ||||
| |||||
| 10.OVERALL ANALYSIS AND TROUBLESHOOTING |
Operation Check (Click here)
Terminals of ECU (Click here)
Data List / Active Test (Click here)
| |||||
| 11.CIRCUIT INSPECTION* |
| |||||
| 12.IDENTIFICATION OF PROBLEM |
| |||||
| 13.REPAIR OR REPLACE |
| |||||
| 14.CONFIRMATION TEST* |
|
| ||||
|---|---|---|---|---|---|