Home › Vehicle Exterior › LIGHTING (EXT) › AUTOMATIC HIGH BEAM SYSTEM

AUTOMATIC HIGH BEAM SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
  1. Use the following procedure to troubleshoot the automatic high beam system.
  2. *: Use the intelligent tester.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.CUSTOMER PROBLEM ANALYSIS CHECK AND SYMPTOM CHECK

      NEXT


      3.INSPECT BATTERY VOLTAGE
      1. Measure the battery voltage.

        Standard Voltage:
        11 to 14 V

        If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.


      NEXT


      4.INSPECT CAN COMMUNICATION SYSTEM*
      1. Use the intelligent tester to check if the CAN communication system is functioning normally (Click here).

        Result:

        Result
        Proceed to
        CAN communication system DTCs are not output
        A
        CAN communication system DTCs are output
        B



      B.
      GO TO CAN COMMUNICATION SYSTEM (Click here)
      A


      5.CHECK FOR DTC*
      1. Check for DTCs (Click here).

        Result:

        Result
        Proceed to
        DTCs are not output
        A
        DTCs are output
        B



      B.
      GO TO DIAGNOSTIC TROUBLE CODE CHART (Click here)
      A


      6.PROBLEM SYMPTOMS TABLE
      1. Refer to Problem Symptoms Table (Click here).

        Result:

        Result
        Proceed to
        Fault is not listed in Problem Symptoms Table
        A
        Fault is listed in Problem Symptoms Table
        B



      B.
      GO TO PROBLEM SYMPTOMS TABLE (Click here)
      A


      7.OVERALL ANALYSIS AND TROUBLESHOOTING*
      1. Data List / Active Test (Click here)

      2. Terminals of ECU (Click here)


      NEXT


      8.ADJUST, REPAIR OR REPLACE

        NEXT


        9.CONFIRMATION TEST

          NEXT

          END