Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM (for Radio and Display Type)

AUDIO AND VISUAL SYSTEM (for Radio and Display Type) > Display does not Dim when Light Control Switch is Turned ON

for Preparation Click here


INSPECTION PROCEDURE

1.CHECK IMAGE QUALITY SETTING
  1. Turn the light control switch to the tail or head position.

  1. Check that the daytime screen setting on the display adjustment screen is set to on.

    Result:
    Result
    Proceed to
    Daytime screen setting is set to on.
    A
    Daytime screen setting is set to off.
    B



B
Go to step 2
A

CHANGE DAYTIME SCREEN SETTING TO OFF 

2.CHECK VEHICLE SIGNAL (OPERATION CHECK)


    E225854
  1. Enter the "Vehicle Signal Check Mode" screen. Refer to Check Vehicle Signal in Operation Check (Click here).

  1. Check that the display changes between ON and OFF according to the light control switch operation.

    OK:
    Light Control Switch
    Display
    Tail or head
    ON
    Off
    OFF

    HINT:
    The display is updated once per second. It is normal for the display to lag behind the actual switch operation.



NG
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
OK

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY (Click here)