DTC P061512 Starter Relay Circuit Short to Battery |
| DTC No. | DTC Detection Condition | Trouble Area |
| P061512 | 1. Diagnosis Condition 2. Malfunction Status 3. Malfunction Time 4. Other
|
|

| 1.READ VALUE USING GTS (STARTER SW) |
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Turn the GTS on.
Enter the following menus: Powertrain / Transmission / Data List / Starter SW.
Check the value displayed on the GTS when the vehicle is driven at 20 km/h (12 mph) or more.
| Condition | GTS Display | Proceed to |
| Driving at 20 km/h (12 mph) or more | OFF | A |
| ON | B |
|
| ||||
| A | ||
| ||
| 2.INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY |
Inspect the park/neutral position switch assembly (Click here).
|
| ||||
| OK | |
| 3.CHECK SMART ENTRY AND START SYSTEM (STA SIGNAL) |
Check the smart entry and start system (for Start Function) (Click here).
|
| ||||
| OK | |
| 4.REPAIR OR REPLACE HARNESS OR CONNECTOR (STA SIGNAL CIRCUIT) |
Repair or replace harness or connector (STA signal circuit).
| NEXT | |
| 5.CHECK WHETHER DTC OUTPUT RECURS (DTC P061512) |
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Turn the GTS on.
Clear the DTCs (Click here).
Turn the engine switch off and wait for at least 30 seconds.
Drive the vehicle in accordance with the driving pattern described in Confirmation Driving Pattern (Click here).
Enter the following menus: Powertrain / Transmission / Trouble Codes.
Read the DTCs (Click here).
| Result | Proceed to |
| DTC P061512 is output | A |
| DTCs are not output | B |
|
| ||||
| A | ||
| ||