DTC P077513 Pressure Control Solenoid "B" Circuit Open |
| DTC No. | DTC Detection Condition | Trouble Area |
| P077513 | 1. Diagnosis Condition 2. Malfunction Status 3. Malfunction Time 4. Other
|
|

| ECM commanded gear | 1st | 2nd | 3rd | 4th | 5th | 6th |
| Shift solenoid valve SL2 | OFF | OFF | OFF | ON | ON | ON |
| 1.CHECK HARNESS AND CONNECTOR (SHIFT SOLENOID VALVE SL2 CIRCUIT) |
Disconnect the E96 ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E96-5 (SL2+) - E96-4 (SL2-) | 20°C (68°F) | 5.0 to 5.6 Ω |
| E96-5 (SL2+) - Body ground and other terminals | Always | 10 kΩ or higher |
| E96-4 (SL2-) - Body ground and other terminals | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||
| 2.CHECK HARNESS AND CONNECTOR (ECM - WIRING HARNESS CONNECTOR) |
Disconnect the E8 connector from the wiring harness connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E96-5 (SL2+) - E8-9 (SL2+) | Always | Below 1 Ω |
| E96-4 (SL2-) - E8-8 (SL2-) | Always | Below 1 Ω |
| E96-5 (SL2+) or E8-9 (SL2+) - Body ground and other terminals | Always | 10 kΩ or higher |
| E96-4 (SL2-) or E8-8 (SL2-) - Body ground and other terminals | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.INSPECT TRANSMISSION WIRE (SL2) |
![]() |
Remove the wiring harness connector.
| *a | Component without harness connected (Transmission Wire) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A-9 (SL2+) - A-8 (SL2-) | 20°C (68°F) | 5.0 to 5.6 Ω |
| A-9 (SL2+) - Body ground and other terminals | Always | 10 kΩ or higher |
| A-8 (SL2-) - Body ground and other terminals | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||
| 4.INSPECT SHIFT SOLENOID VALVE SL2 |
![]() |
Remove the shift solenoid valve SL2.
| *1 | Shift Solenoid Valve SL2 |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 1 - 2 | 20°C (68°F) | 5.0 to 5.6 Ω |
Connect a positive (+) lead from the battery with a 21 W bulb to terminal 2 and a negative (-) lead to terminal 1 of the solenoid valve connector. Check that the valve moves and makes an operating sound.
|
| ||||
| OK | ||
| ||