DTC C1241 Low Power Supply Voltage Malfunction |
| DTC No. | DTC Detection Condition | Trouble Area |
| C1241 | Any of the following is detected:
|
|

| 1.CHECK BATTERY |
Check the battery voltage.
| Result | Proceed to |
| OK | A |
| NG (for 2GR-FE) | B |
| NG (for 2AR-FE) | C |
| NG (for 6AR-FSE) | D |
|
| ||||
|
| ||||
|
| ||||
| A | |
| 2.CHECK HARNESS AND CONNECTOR (POWER SOURCE TERMINAL) |
![]() |
Make sure that there is no looseness at the locking part and the connecting part of the connector.
Disconnect the skid control ECU connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A49-25 (+BS) - Body ground | Always | 11 to 14 V |
| A49-25 (+BS) - A49-38 (GND1) | Always | 11 to 14 V |
| A49-28 (IG1) - Body ground | Ignition switch ON | 11 to 14 V |
| A49-28 (IG1) - A49-38 (GND1) | Ignition switch ON | 11 to 14 V |
| *a | Front view of wire harness connector (to Skid Control ECU (Brake Actuator Assembly)) |
| Result | Proceed to |
| OK | A |
| NG (for +BS circuit) | B |
| NG (for IG1 circuit) | C |
|
| ||||
|
| ||||
| A | |
| 3.CHECK HARNESS AND CONNECTOR (GND1 TERMINAL) |
![]() |
Turn the ignition switch off.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A49-38 (GND1) - Body ground | Always | Below 1 Ω |
| *a | Front view of wire harness connector (to Skid Control ECU (Brake Actuator Assembly)) |
|
| ||||
| OK | |
| 4.RECONFIRM DTC |
Reconnect the skid control ECU connector.
Clear the DTCs (Click here).
Turn the ignition switch off.
Start the engine.
Perform a road test.
Check if the same DTC is output (Click here).
| Result | Proceed to |
| DTC C1241 is not output. | A |
| DTC C1241 is output. | B |
|
| ||||
| A | ||
| ||
| 5.CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - ENGINE ROOM RELAY BLOCK AND JUNCTION BLOCK ASSEMBLY) |
Turn the ignition switch off.
Disconnect the engine room relay block and junction block assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A49-25 (+BS) - 1L-1 | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
| A49-25 (+BS) - 1I-1 | Always | Below 1 Ω |
|
| ||||
| OK | ||
| ||