Home › Vehicle Interior › SEAT BELT › SEAT BELT WARNING SYSTEM (w/ Occupant Classification System)

SEAT BELT WARNING SYSTEM (w/ Occupant Classification System) > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
  1. Use this procedure to troubleshoot the seat belt warning system.
  2. *: Use the GTS.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.CUSTOMER PROBLEM ANALYSIS
    1. Interview the customer to confirm the trouble (Click here).


    NEXT


    3.INSPECT BATTERY VOLTAGE
    1. Measure the battery voltage .

      Standard Voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.


    NEXT


    4.CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*
    1. Use the GTS to check if the CAN communication system is functioning normally (Click here).

      Result:
      Result
      Proceed to
      CAN DTC is not output
      A
      CAN DTC is output
      B



    B.
    GO TO CAN COMMUNICATION SYSTEM (Click here)
    A


    5.CHECK DTC OUTPUT (AIRBAG SYSTEM)*
    1. Clear DTCs (Click here).

    2. Recheck for DTCs (Click here).

      Result:
      Result
      Proceed to
      DTC is not output
      A
      DTC is output
      B



    B.
    GO TO AIRBAG SYSTEM (Click here)
    A


    6.CHECK DTC OUTPUT (OCCUPANT CLASSIFICATION SYSTEM)*
    1. Clear DTCs (Click here).

    2. Recheck for DTCs (Click here).

      Result:
      Result
      Proceed to
      DTC is not output
      A
      DTC is output
      B



    B.
    GO TO OCCUPANT CLASSIFICATION SYSTEM (Click here)
    A


    7.CHECK COMBINATION METER ASSEMBLY
    1. Check that the operation of the speedometer, shift indicator and brake warning light on the combination meter assembly.

      OK:
      The speedometer, shift indicator and brake warning light on the combination meter assembly operate normally.



    NG.
    GO TO METER / GAUGE SYSTEM (Click here)
    OK


    8.PROBLEM SYMPTOMS TABLE
    1. Refer to Problem Symptoms Table (Click here).

      Result:
      Result
      Proceed to
      Fault is not listed in problem symptoms table
      A
      Fault is listed in problem symptoms table
      B



    B.
    Go to step 10
    A


    9.OVERALL ANALYSIS AND TROUBLESHOOTING*
    1. Data List / Active Test (Click here)

    2. Terminals of ECU (Click here)

    3. On-vehicle Inspection (Click here)


    NEXT


    10.REPAIR OR REPLACE

      NEXT


      11.CONFIRMATION TEST

        NEXT

        END