Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › OCCUPANT CLASSIFICATION SYSTEM (for TMMK Made)

DTC    B1785    Front Occupant Classification Sensor LH Collision Detection

for Preparation Click here


DESCRIPTION

DTC B1785 is stored when the occupant detection ECU receives a collision detection signal sent by the front occupant classification sensor LH if an accident occurs.
DTC B1785 is also stored when the front seat assembly RH is subjected to a strong impact, even if an actual accident does not occur.
If the vehicle was not in a collision, but the occupant detection ECU receives a collision detection signal and stores DTC B1785, the DTC can be cleared by performing Zero Point Calibration and Sensitivity Check.
Therefore, if DTC B1785 is output, first perform Zero Point Calibration and Sensitivity Check.

DTC No.
DTC Detection Condition
Trouble Area
B1785
  1. Front occupant classification sensor LH sensed large load
  2. Front seat frame with adjuster assembly RH malfunction
  1. Front seat frame with adjuster assembly RH (Front occupant classification sensor LH)*
  1. *: The front occupant classification sensor LH is built into the front seat frame with adjuster assembly RH.

WIRING DIAGRAM

Refer to DTC B1780 .

INSPECTION PROCEDURE

NOTICE:
After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work (Click here).

HINT:
When DTC B1650/32 is detected as a result of troubleshooting for the airbag system, check for DTCs stored in the occupant detection ECU. When DTC B1785 is output, perform troubleshooting for the DTC.

1.PERFORM ZERO POINT CALIBRATION AND SENSITIVITY CHECK
  1. Using the GTS, perform Zero Point Calibration and Sensitivity Check (Click here).

    OK:
    "Zero Point Calibration is complete." and "Sensitivity Check is complete." are displayed.



NG
Go to step 3
OK


2.CHECK DTC
  1. Clear the DTCs stored in the occupant detection ECU (Click here).

  1. Clear the DTCs stored in the airbag sensor assembly (Click here).

  1. Turn the engine switch off.

  1. Turn the engine switch on (IG).

  1. Check for DTCs (Click here).

    OK:
    DTC B1785 is not output.

    HINT:
    Codes other than DTC B1785 may be output at this time, but they are not related to this check.

  1. Turn the engine switch off.



NG
Go to step 3
OK

END 

3.REPLACE FRONT SEAT FRAME WITH ADJUSTER ASSEMBLY RH
  1. Disconnect the cable from the negative (-) battery terminal.

  1. Replace the front seat frame with adjuster assembly RH (Click here for Manual Seat, Click here for Power Seat).

  1. Connect the cable to the negative (-) battery terminal.


NEXT


4.PERFORM ZERO POINT CALIBRATION AND SENSITIVITY CHECK
  1. Using the GTS, perform Zero Point Calibration and Sensitivity Check (Click here).


NEXT

END