Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › OCCUPANT CLASSIFICATION SYSTEM (for TMMK Made)

DTC    B1795    Occupant Classification ECU Malfunction

for Preparation Click here


DESCRIPTION

DTC B1795 is stored when a malfunction is detected in the occupant detection ECU.

DTC No.
DTC Detection Condition
Trouble Area
B1795
Occupant detection ECU malfunction
Occupant detection ECU

INSPECTION PROCEDURE

NOTICE:
After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work (Click here).

HINT:
When DTC B1650/32 is detected as a result of troubleshooting for the airbag system, check for DTCs stored in the occupant detection ECU. When DTC B1795 is output, perform troubleshooting for the DTC.

1.REPLACE OCCUPANT DETECTION ECU
  1. Turn the engine switch off.

  1. Disconnect the cable from the negative (-) battery terminal.

  1. Replace the occupant detection ECU (Click here).

  1. Connect the cable to the negative (-) battery terminal.


NEXT


2.PERFORM ZERO POINT CALIBRATION AND SENSITIVITY CHECK
  1. Using the GTS, perform Zero Point Calibration and Sensitivity Check (Click here).


NEXT

END