Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › OCCUPANT CLASSIFICATION SYSTEM (for TMMK Made)

DTC    B1796    Sleep Operation Failure of Occupant Classification ECU

for Preparation Click here


DESCRIPTION

In sleep mode, the occupant detection ECU reads the condition of each sensor while the engine switch is off.
In this mode, if the occupant detection ECU detects an internal malfunction, DTC B1796 is stored.

DTC No.
DTC Detection Condition
Trouble Area
B1796
  1. Occupant detection ECU malfunction
  1. Occupant detection ECU

INSPECTION PROCEDURE

NOTICE:
After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work (Click here).

1.REPLACE OCCUPANT DETECTION ECU
  1. Turn the engine switch off.

  1. Disconnect the cable from the negative (-) battery terminal.

  1. Replace the occupant detection ECU (Click here).

  1. Connect the cable to the negative (-) battery terminal.


NEXT


2.PERFORM ZERO POINT CALIBRATION AND SENSITIVITY CHECK
  1. Using the GTS, perform Zero Point Calibration and Sensitivity Check (Click here).


NEXT

END