DTC B1796 Sleep Operation Failure of Occupant Classification ECU |
| DTC No. | DTC Detection Condition | Trouble Area |
| B1796 |
|
|
| 1.REPLACE OCCUPANT DETECTION ECU |
Turn the engine switch off.
Disconnect the cable from the negative (-) battery terminal.
Replace the occupant detection ECU (Click here).
Connect the cable to the negative (-) battery terminal.
| NEXT | |
| 2.PERFORM ZERO POINT CALIBRATION AND SENSITIVITY CHECK |
Using the GTS, perform Zero Point Calibration and Sensitivity Check (Click here).
| NEXT | ||
| ||