Home › Suspension › REAR SUSPENSION › REAR LOWER ARM (for TMMK Made)

REAR LOWER ARM (for TMMK Made) > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedure for the RH side and LH side.
  2. The procedure listed below is for the LH side.
  3. The rear No. 2 suspension arm assembly can be installed directly to the vehicle.



1. INSTALL REAR NO. 1 SUSPENSION ARM ASSEMBLY


    C239077
  1. Temporarily tighten the rear No. 1 suspension arm assembly (inner side) with the bolt.
    Text in Illustration 
    V100135
    Bolt
    V100136
    Front of the Vehicle
    V100143
    Paint Mark

    HINT:
    Ensure that the paint mark faces the rear of the vehicle.



    C132503E07
  1. Set the rear No.1 suspension arm assembly in the position shown in the illustration, and fully tighten the bolt.

    Torque:
    100 N*m{ 1020 kgf*cm , 74 ft.*lbf }



2. INSTALL REAR SUSPENSION MEMBER SUB-ASSEMBLY
(Click here)


3. TEMPORARILY TIGHTEN REAR NO. 2 SUSPENSION ARM ASSEMBLY


    C239075
  1. Temporarily tighten the rear No. 2 suspension arm assembly (inside) with the bolt.
    Text in Illustration 
    V100135
    Bolt
    V100143
    Paint Mark

    HINT:
    Ensure that the paint mark faces the rear of the vehicle.



4. CONNECT REAR NO. 2 SUSPENSION ARM ASSEMBLY
  1. Connect the rear No. 2 suspension arm assembly (outer side) to the rear axle carrier sub-assembly with the bolt and nut.

    NOTICE:
    When temporarily tightening the bolt, keep the nut from rotating.

    HINT:
    Insert the bolt from the rear of the vehicle.



5. STABILIZE SUSPENSION


    C239098E01
  1. Jack up the rear axle carrier sub-assembly, placing a wooden block under it to avoid damage. Apply load to the suspension so that the installed bolt of the rear No. 1 suspension arm assembly (inner side) is horizontally aligned with the center of the rear axle hub.
    Text in Illustration 
    *1
    Wooden Block

    CAUTION:
    Do not jack up the rear axle carrier sub-assembly too high as the vehicle may fall.

    NOTICE:
    1. When jacking up the rear axle carrier sub-assembly, be sure to jack it up slowly.
    2. Make sure to perform this operation with the vehicle kept as low as possible.



6. FULLY TIGHTEN REAR NO. 2 SUSPENSION ARM ASSEMBLY


    C239642
  1. Fully tighten the 2 bolts.

    Torque:
    100 N*m{ 1020 kgf*cm , 74 ft.*lbf }



7. INSTALL REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY (for RH Side)
(Click here)


8. INSTALL REAR WHEELS

Torque:
103 N*m{ 1049 kgf*cm , 76 ft.*lbf }



9. INSPECT AND ADJUST REAR WHEEL ALIGNMENT
(Click here)


10. HEIGHT CONTROL SENSOR SIGNAL INITIALIZE (for RH Side)
(Click here)


11. ADJUST HEADLIGHT AIMING (for RH Side)
(Click here)