Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › OCCUPANT CLASSIFICATION ECU (for TMMK Made)

OCCUPANT CLASSIFICATION ECU (for TMMK Made) > INSTALLATION

for Preparation Click here



1. INSTALL OCCUPANT DETECTION ECU


    B278817
  1. Engage the claw to install the occupant detection ECU.

    NOTICE:
    If the occupant detection ECU has been dropped, or there are any cracks, dents or other defects in the case or connector, replace the occupant detection ECU with a new one.

  1. Connect the 2 connectors.

    NOTICE:
    When installing the occupant detection ECU, be careful that the SRS wiring does not interfere with or is pinched between other parts.



2. INSTALL FRONT SEAT ASSEMBLY RH (for Manual Seat)
(Click here)


3. INSTALL FRONT SEAT ASSEMBLY RH (for Power Seat)

HINT:
Use the same procedure for the RH side and LH side.
(Click here)



4. PERFORM DIAGNOSTIC SYSTEM CHECK
(Click here)


5. PERFORM ZERO POINT CALIBRATION AND SENSITIVITY CHECK
(Click here)