DTC B241A Rear Height Control Sensor |
| DTC No. | DTC Detecting Condition | Trouble Area |
| B241A |
|
|

| 1.CHECK FOR DTC |
Clear the DTCs (Click here).
Check for DTCs (Click here).
|
| ||||
| OK | ||
| ||
| 2.READ VALUE USING INTELLIGENT TESTER |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Body / HL AutoLeveling / Data List.
Read the display on the intelligent tester.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Height Sens Pw Supply Val | Rear height control sensor power supply value / 0.00 to 5.00 V | Approx. 5 V | - |
| Rr Height Sens Signal Val | Rear height control sensor signal value / 0.00 to 5.00 V | Approx. 2.5 V (When the vehicle is level) | Value changes according to vehicle height |
|
| ||||
| OK | ||
| ||
| 3.INSPECT REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY |
Remove the rear height control sensor sub-assembly (for TMC, TMMR Made: Click here), (for TMMK Made: Click here).
Inspect the rear height control sensor sub-assembly (for TMC, TMMR Made: Click here), (for TMMK Made: Click here).
| Result | Proceed to |
| OK | A |
| NG (for TMC, TMMR Made) | B |
| NG (for TMMK Made) | C |
|
| ||||
|
| ||||
| A | |
| 4.CHECK HARNESS AND CONNECTOR (HEADLIGHT LEVELING ECU ASSEMBLY - REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY) |
Disconnect the A34 headlight leveling ECU assembly connector.
Disconnect the O17 rear height control sensor sub-assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A34-19 (SHRL) - O17-2 (SHRR) | Always | Below 1 Ω |
| A34-19 (SHRL) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||