LIGHTING SYSTEM > Front Door Courtesy Switch Circuit |

| 1.READ VALUE USING INTELLIGENT TESTER |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Body / Main Body / Data List.
Read the display on the intelligent tester.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| FR Door Courtesy | Front door courtesy light switch RH signal/ON or OFF | ON: Front door RH closed OFF: Front door RH open | - |
| FL Door Courtesy | Front door courtesy light switch LH signal/ON or OFF | ON: Front door LH closed OFF: Front door LH open | - |
| Result | Proceed to |
| OK | A |
| Front door courtesy light switch LH or RH does not operate | B |
|
| ||||
| A | ||
| ||
| 2.INSPECT FRONT DOOR COURTESY LIGHT SWITCH ASSEMBLY (LH OR RH) |
Remove the front door courtesy light switch assembly (for TMC, TMMR Made) (Click here).
Remove the front door courtesy light switch assembly (for TMMK Made) (Click here).
Inspect the front door courtesy light switch assembly (for TMMK Made) (Click here).
Inspect the front door courtesy light switch assembly (for TMC, TMMR Made) (Click here).
| Result | Proceed to |
| OK (for Front LH) | A |
| OK (for Front RH) | B |
| NG (for TMC, TMMR Made) | C |
| NG (for TMMK Made) | D |
|
| ||||
|
| ||||
|
| ||||
| A | |
| 3.CHECK HARNESS AND CONNECTOR (FRONT DOOR COURTESY LIGHT SWITCH ASSEMBLY LH - INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY) |
Disconnect the 3C instrument panel junction block assembly connector.
Disconnect the N7 front door courtesy light switch assembly LH connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| N7-1 - 3C-15 | Always | Below 1 Ω |
| N7-1 - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 4.INSPECT INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY |
Remove the instrument panel junction block assembly (Click here).
Remove the main body ECU (multiplex network body ECU) from the instrument panel junction block assembly.
Measure the resistance according to the value(s) in the table below.

| *a | Component without harness connected (Instrument Panel Junction Block Assembly) | - | - |
| Tester Connection | Condition | Specified Condition |
| 3C-15 - MB-2 (FLCY) | Always | Below 1 Ω |
|
| ||||
| OK | ||
| ||
| 5.CHECK HARNESS AND CONNECTOR (FRONT DOOR COURTESY LIGHT SWITCH ASSEMBLY RH - MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)) |
Disconnect the I13 main body ECU (multiplex network body ECU) connector.
Disconnect the O10 front door courtesy light switch assembly RH connector.
Disconnect the J2 courtesy light assembly RH connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| O10-1 - I13-19 (FRCY) | Always | Below 1 Ω |
| O10-1 - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||