METER / GAUGE SYSTEM > Speedometer Malfunction |

| 1.CHECK CAN COMMUNICATION SYSTEM |
Check if a CAN communication DTC is output (Click here).
| Result | Proceed to |
| CAN communication DTCs are not output. | A |
| CAN communication DTCs are output. | B |
|
| ||||
| A | |
| 2.PERFORM ACTIVE TEST USING GTS (SPEED METER OPERATION) |
Connect the GTS to the DLC3.
Turn the ignition switch ON.
Turn the GTS on.
Enter the following menus: Body Electrical / Combination Meter / Active Test.
Perform the Active Test according to the display on the GTS.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Speed Meter Operation | Speedometer | 0, 40, 80, 120, 160, 200, 240* km/h | There is a deviation in the values displayed on the speedometer (Control range → Speedometer display)
|
|
| ||||
| OK | |
| 3.CHECK VEHICLE STABILITY CONTROL SYSTEM |
Check if vehicle stability control system DTCs are output (Click here).
| Result | Proceed to |
| Vehicle stability control system DTCs are not output. | A |
| Vehicle stability control system DTCs are output. | B |
|
| ||||
| A | |
| 4.READ VALUE USING GTS (VEHICLE SPEED, VEHICLE SPEED METER) |
Connect the GTS to the DLC3.
Turn the ignition switch ON.
Turn the GTS on.
Enter the following menus:
for ABS/VSC/TRC: Chassis / ABS/VSC/TRC / Data List.
for Combination Meter: Body Electrical / Combination Meter / Data List.
Read the Data List according to the display on the GTS.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Vehicle Speed | Vehicle speed/Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph) | Vehicle stopped: 0 km/h (0 mph) | When driving at constant speed: No large fluctuations |
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Vehicle Speed Meter | Vehicle speed/Min.: 0 km/h (0 mph), Max.: 255 km/h (158 mph) | Almost the same as actual vehicle speed | - |
| Result | Proceed to |
| The data list values of the ECUs match. | A |
| The data list values of the ECUs do not match. | B |
|
| ||||
| A | ||
| ||
| 5.REPLACE COMBINATION METER ASSEMBLY |
Replace the combination meter assembly with a new or known good one (Click here).
| Result | Proceed to |
| The operation of the speedometer returns to normal. | A |
| The operation of the speedometer does not returns to normal. | B |
|
| ||||
| A | ||
| ||