Home › Suspension › TIRE / WHEEL › TIRE AND WHEEL SYSTEM (for TMMK Made)

TIRE AND WHEEL SYSTEM (for TMMK Made) > INSPECTION

for Preparation Click here



1. INSPECT TIRES
  1. Check the tires for wear and proper inflation pressure.

    Cold Tire Inflation Pressure:

    Tire Size
    Front
    kPa (kgf/cm2, psi)
    Rear
    kPa (kgf/cm2, psi)
    P215/55R17 93V
    210 (2.1, 30)



    C137874
  1. Using a dial indicator, check the runout of the tires.

    Maximum Tire Runout:
    1.4 mm (0.0551 in.)



2. ROTATE TIRES


    C163157
  1. Rotate the tires as shown in the illustration.
    Text in Illustration 
    V100135
    Front



3. INSPECT AND ADJUST WHEEL BALANCE


    C144018E10
  1. Inspect and adjust the off-the-car balance.
    Text in Illustration 
    *a
    25 mm (0.984 in.)

    Maximum Wheel Imbalance:
    8.0 g (0.0176 lb)

    NOTICE:
    1. Use a cleaning detergent to remove dirt, oil and water from the surface where the balance weight is to be adhered.
    2. Do not touch the adhesive surface of the tape.
    3. Adhere a sticking type balance weight to the flat surface*a shown in the illustration.
    4. Push the balance weight securely with your finger to adhere it to the desired position.
    5. Do not reuse balance weights.

    HINT:
    The inner side balance weight should be installed by clipping it to the rim.



4. INSPECT FRONT AXLE HUB BEARING
(Click here)


5. INSPECT REAR AXLE HUB BEARING
(Click here)