TIRE AND WHEEL SYSTEM (for TMMK Made) > INSPECTION |
| 1. INSPECT TIRES |
Check the tires for wear and proper inflation pressure.
| Tire Size | Front kPa (kgf/cm2, psi) | Rear kPa (kgf/cm2, psi) |
| P215/55R17 93V | 210 (2.1, 30) | |
Perform initialization (Click here).
Tire pressure adjustment method when warm:
Turn the engine switch off.
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Turn the GTS on.
Enter the following menus: Chassis / Tire Pressure Monitor / Data List.
Adjust the tire pressure so that the displayed value is equal to the set pressure.
Perform initialization and check that initialization completes (Click here).
Check and record the value of the Data List item "Temperature in Tire". (Ts)
Check and record the ambient temperature during tire pressure adjustment. (Tm)
Readjust the tire pressure according to the difference between the tire internal temperature (Ts) and the ambient temperature (Tm). (P)
Check the pressure adjustment value with the Data List item "Tire Inflation Pressure".
![]() |
Using a dial indicator, check the runout of the tires.
| 2. ROTATE TIRES |
![]() |
Rotate the tires as shown in the illustration.
![]() | Front |
Perform initialization (Click here).
| 3. INSPECT AND ADJUST WHEEL BALANCE |
![]() |
Inspect and adjust the off-the-car balance.
| *a | 25 mm (0.984 in.) |
| 4. INSPECT FRONT AXLE HUB BEARING |
| 5. INSPECT REAR AXLE HUB BEARING |