Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM

VEHICLE STABILITY CONTROL SYSTEM > TRC OFF Indicator Light does not Come ON

for Preparation Click here


DESCRIPTION

The skid control ECU is connected to the combination meter assembly via CAN communication.

INSPECTION PROCEDURE

1.CHECK CAN COMMUNICATION SYSTEM
  1. Check if a CAN communication system DTC is output (Click here).

    Result:

    Result
    Proceed to
    DTC is not output.
    A
    DTC is output.
    B



B
INSPECT CAN COMMUNICATION SYSTEM (Click here)
A


2.PERFORM ACTIVE TEST USING INTELLIGENT TESTER (MULTI-INFORMATION DISPLAY (TRC OFF MESSAGE))
  1. Connect the intelligent tester to the DLC3.

  1. Start the engine.

  1. Select the Active Test on the intelligent tester (Click here).

    ABS/VSC/TRC 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    TRC(TRAC) OFF Indicator Light
    Multi-information display (TRC OFF message)
    Display (message) ON/OFF
    Observe combination meter assembly

  1. Check that the multi-information display (TRC OFF message) on the combination meter assembly turns on or off in accordance with the intelligent tester operation.

    OK:
    The multi-information display (TRC OFF message) turns on or off in accordance with the Active Test operation.

    HINT:
    If troubleshooting has been carried out according to Problem Symptoms Table, refer back to the table and proceed to the next step before replacing parts (Click here).



NG
Go to step 3
OK

REPLACE BRAKE ACTUATOR ASSEMBLY (Click here)  

3.INSPECT COMBINATION METER ASSEMBLY
  1. Turn the ignition switch off.

  1. Perform an Active Test of the combination meter assembly (meter CPU) using the intelligent tester (Click here).

  1. Check the combination meter assembly.

    OK:
    The multi-information display turns on or off in accordance with the Active Test operation.

    HINT:
    If troubleshooting has been carried out according to Problem Symptoms Table, refer back to the table and proceed to the next step before replacing parts (Click here).



NG
REPLACE COMBINATION METER ASSEMBLY (Click here)
OK

REPLACE BRAKE ACTUATOR ASSEMBLY (Click here)