Home › Vehicle Exterior › LIGHTING (EXT) › HEADLIGHT ASSEMBLY (for TMC, TMMR Made)

HEADLIGHT ASSEMBLY (for TMC, TMMR Made) > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedure for the RH side and LH side.
  2. The following procedure is for the LH side.



1. INSTALL HEADLIGHT ASSEMBLY
  1. Connect each connector.

  1. Engage each clamp.

  1. Install the headlight assembly with the 3 screws and bolt.

    Torque:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }



2. INSTALL FRONT BUMPER ASSEMBLY
(Click here)


3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (for HID Headlight)

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



4. ADJUST HEADLIGHT AIMING
(Click here)


5. ADJUST FOG LIGHT AIMING
(Click here)