Home › Vehicle Exterior › LIGHTING (EXT) › HEADLIGHT ASSEMBLY (for TMC, TMMR Made)

HEADLIGHT ASSEMBLY (for TMC, TMMR Made) > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for the RH side and LH side.
  2. The following procedure is for the LH side.



1. PRECAUTION (for HID Headlight)
(Click here)

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (for HID Headlight)

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



3. REMOVE FRONT BUMPER ASSEMBLY
(Click here)


4. REMOVE HEADLIGHT ASSEMBLY


    E301867
  1. Remove the 3 screws and bolt.

  1. Disengage each clamp.

  1. Disconnect each connector and remove the headlight assembly.