WIPER SWITCH > INSTALLATION |
| 1. INSTALL WINDSHIELD WIPER SWITCH ASSEMBLY |
![]() |
Engage the claw to install the windshield wiper switch assembly as shown in the illustration.
Connect each connector.
| 2. INSTALL UPPER STEERING COLUMN COVER |
Engage the 2 claws to install the upper steering column cover.
Engage the 4 clips and 2 guides to install the instrument cluster finish panel to the upper steering column cover.
| 3. INSTALL LOWER STEERING COLUMN COVER (for Power Tilt and Power Telescopic Steering Column) |
Engage the 2 claws.
install the screw.
Turn the steering wheel assembly to the left and install the screw.
Turn the steering wheel assembly to the right and install the lower steering column cover with the screw.
| 4. INSTALL LOWER STEERING COLUMN COVER (for Manual Tilt and Manual Telescopic Steering Column) |
Engage the 2 claws.
![]() |
Engage the 2 claws.
Turn the steering wheel assembly to the left and install the screw.
Turn the steering wheel assembly to the right and install the lower steering column cover with the screw.
| 5. INSTALL INSTRUMENT PANEL SUB-ASSEMBLY (for Power Tilt and Power Telescopic Steering Column) |
w/o Driver Side Knee Airbag:
Engage the 5 clips and 3 guides.
w/ Driver Side Knee Airbag:
Engage the 4 claws, 7 clips and 3 guides.
Install the instrument panel sub-assembly with the 2 bolts <B>.
| 6. CONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY (for Power Tilt and Power Telescopic Steering Column) |
Engage the claw and 2 guides to connect the hood lock control lever sub-assembly.
| 7. INSTALL FRONT PANEL GARNISH LH (for Power Tilt and Power Telescopic Steering Column) |
![]() |
Engage the 3 clips and 8 guides to install the front panel garnish LH.
| 8. INSTALL INSTRUMENT SIDE PANEL LH (for Power Tilt and Power Telescopic Steering Column) |
Engage the 3 guides.
![]() |
Engage the 4 claws to install the instrument side panel LH as shown in the illustration.
| 9. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP LH (for Power Tilt and Power Telescopic Steering Column) |
![]() |
Align the alignment mark (Yellow) on the weatherstrip with the protruding portion on the body indicated by the arrow in the illustration, and install the front door opening trim weatherstrip LH.
| *1 | Alignment Mark (Yellow) |
| 10. INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH (for Power Tilt and Power Telescopic Steering Column) |
Engage the 2 clips.
Install the cowl side trim sub-assembly LH with the clip.
| 11. INSTALL FRONT DOOR SCUFF PLATE LH (for Power Tilt and Power Telescopic Steering Column) |
Engage the 10 claws to install the front door scuff plate LH.
| 12. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (for Power Tilt and Power Telescopic Steering Column) |