PARKING BRAKE PEDAL (for LHD) > REMOVAL |
| 1. PRECAUTION |
| 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 3. REMOVE SHIFT LEVER SUPPORT |
| 4. REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (w/ Driver Side Knee Airbag) |
| 5. REMOVE NO. 1 INDOOR ELECTRICAL KEY ANTENNA ASSEMBLY (w/ Smart Entry and Start System) |
![]() |
Disengage the clamp.
Remove the bolt.
Disconnect the connector to remove the No. 1 indoor electrical key antenna assembly.
| 6. REMOVE FLOOR CARPET BRACKET RH |
| 7. REMOVE AIRBAG SENSOR ASSEMBLY |
| 8. LOOSEN ADJUSTING NUT |
![]() |
Remove the lock nut and loosen the adjusting nut.
| *1 | Lock Nut |
| *2 | Adjusting Nut |
| 9. SEPARATE NO. 4 PARKING BRAKE CABLE ASSEMBLY |
for TMC, TMMR Made:
![]() |
Separate the No. 4 parking brake cable assembly from the parking brake control pedal assembly as shown in the illustration.
| *a | Turn |
| *b | Hold |
for TMMK Made:
![]() |
Separate the No. 4 parking brake cable assembly from the parking brake control pedal assembly as shown in the illustration.
| *a | Turn |
| *b | Hold |
| 10. REMOVE PARKING BRAKE CONTROL PEDAL ASSEMBLY |
Turn back the floor carpet.
![]() |
Remove the clip from the No. 1 parking brake cable assembly.
Remove the bolt and 2 nuts, and separate the No. 1 parking brake cable assembly.
![]() |
Disconnect the parking brake switch connector.
![]() |
Remove the bolt, 2 nuts and parking brake control pedal assembly.