POWER WINDOW CONTROL SYSTEM (for Models with Jam Protection Function on Front Door Windows) > Auto Up Operation does not Fully Close Power Window (Jam Protection Function is Activated) |
| 1.PERFORM INITIALIZATION (APPLICABLE LOCATION) |
Initialize the power window regulator motor assembly (applicable location) (Click here).
| NEXT | |
| 2.CHECK POWER WINDOW CONTROL SYSTEM (AUTO UP / DOWN FUNCTION (APPLICABLE LOCATION)) |
Check that each power window moves when the auto up and down function of the power window regulator master switch assembly or power window regulator switch assembly is operated (Click here).
|
| ||||
| OK | ||
| ||
| 3.CHECK WINDOW GLASS SLIDING MOVEMENT (APPLICABLE LOCATION) |
Remove the window regulator.
Install the window glass to the door glass run.
Check if the door window regulator operates smoothly.
Check that the window glass slides smoothly when sliding it up by hand.
|
| ||||
| OK | ||
| ||