Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ENGINE IMMOBILISER SYSTEM (w/ Smart Entry and Start System)

DTC    B279C    Theft Deterrent System Presence Detection

DTC    B279C95    Engine Immobiliser System Incorrect Assembly

for Preparation Click here


DESCRIPTION

This code is stored when an ECM that is incompatible with the engine immobiliser system is installed to the vehicle.

DTC Code
DTC Detection Condition
Trouble Area
DTC Output Confirmation Operation
B279C
An ECM that is incompatible with the engine immobiliser system is installed (1 trip detection logic*).
ECM
Check for DTCs.
  1. *: Only output while a malfunction is present.

Vehicle Condition and Fail-safe Operation when Malfunction Detected 
Vehicle Condition when Malfunction Detected
Fail-safe Operation when Malfunction Detected
Engine cannot be started
-

Related Data List and Active Test 
DTC Code
Data List and Active Test
  1. B279C*1
  2. B279C95*2
-
  1. *1: for 2GR-FE or 2AR-FE
  2. *2: for 6AR-FSE

INSPECTION PROCEDURE

1.REPLACE ECM
  1. Temporarily replace the ECM with a new one (Click here for 2GR-FE, Click here for 2AR-FE, Click here for 6AR-FSE).


NEXT


2.REGISTER ECU COMMUNICATION ID
  1. Register the ECU communication ID.

    HINT:
    Refer to Service Bulletin.


NEXT


3.CLEAR DTC
  1. Clear the DTCs (Click here).


NEXT


4.CHECK FOR DTC
  1. Check for DTCs (Click here).

    OK:
    B279C*1 or B279C95*2 is not output.

    Result:
    Result
    Proceed to
    DTC B279C*1 or B279C95*2 is not output
    A
    DTC B279C*1 or B279C95*2 is output
    B

  1. *1: for 2GR-FE or 2AR-FE
  2. *2: for 6AR-FSE


B
USE SIMULATION METHOD TO CHECK (Click here)
A

END (ECM WAS DEFECTIVE)