BRAKE PEDAL (for LHD) > ADJUSTMENT |
| 1. INSPECT AND ADJUST BRAKE PEDAL HEIGHT |
Check the brake pedal height.
Turn back the carpet.
Turn back the dash panel insulator assembly from the slit provided on the dash panel insulator assembly.
![]() |
Measure the shortest distance between the brake pedal pad surface and dash panel sub-assembly.
| *1 | Stop Light Switch Assembly |
| *2 | Dash Panel Sub-assembly |
| *a | Brake Pedal Height |
Adjust the push rod length.
Remove the stop light switch assembly .
Remove the brake booster assembly (Click here).
![]() |
Loosen the lock nut and adjust the push rod length shown in the illustration by turning the brake master cylinder push rod clevis to achieve the correct length.
| *1 | Lock Nut |
| *2 | Brake Master Cylinder Push Rod Clevis |
| *a | Push Rod Length |
Tighten the lock nut.
Install the brake booster assembly (Click here).
Install the stop light switch assembly .
After adjusting the pedal height, check the brake pedal free play.
| 2. INSPECT BRAKE PEDAL FREE PLAY |
Stop the engine and firmly depress the brake pedal several times until no vacuum is left in the booster.
![]() |
Depress the pedal until a slight resistance is felt. Measure the distance as shown in the illustration.
| *a | Brake Pedal Free Play |
| 3. INSPECT BRAKE PEDAL RESERVE DISTANCE |
Release the parking brake.
With the engine running, depress the brake pedal and measure the pedal reserve distance.
| Model | Specification |
| for 6AR-FSE | More than 93 mm (3.66 in.) |
| for 2AR-FE, 2GR-FE | More than 96 mm (3.78 in.) |