BRAKE BOOSTER (for LHD) > INSTALLATION |
| 1. INSTALL VACUUM WARNING SWITCH ASSEMBLY (for 6AR-FSE) |
Install a new check valve grommet to the brake booster assembly.
![]() |
Install the vacuum warning switch assembly to the brake booster assembly as shown in the illustration.
| *a | 30° +/- 10° |
![]() | Up |
| 2. INSTALL BRAKE VACUUM CHECK VALVE ASSEMBLY |
Install a new check valve grommet to the brake booster assembly.
Install the brake vacuum check valve assembly to the brake booster assembly.
| 3. INSTALL BRAKE MASTER CYLINDER PUSH ROD CLEVIS |
Temporarily install the lock nut and brake master cylinder push rod clevis to the brake booster assembly.
![]() |
Set the push rod length as shown in the illustration.
| *1 | Lock Nut |
| *2 | Brake Master Cylinder Push Rod Clevis |
| *a | Push Rod Length |
Tighten the lock nut.
| 4. INSTALL BRAKE BOOSTER GASKET |
Install a new brake booster gasket to the brake booster assembly.
| 5. INSTALL BRAKE BOOSTER ASSEMBLY |
Install the brake booster assembly to the vehicle body with the 4 nuts.
| 6. INSTALL PUSH ROD PIN |
![]() |
Apply lithium soap base glycol grease to the push rod pin.
![]() | Lithium Soap Base Glycol Grease |
Connect the brake master cylinder push rod clevis to the brake pedal support assembly with the push rod pin, and install a new clip as shown in the illustration.
| 7. INSTALL NO. 1 HOSE TO HOSE TUBE (for 2AR-FE) |
Install the No. 1 hose to hose tube to the vehicle body with the 2 nuts.
Connect the No. 1 hose to hose tube to the brake booster assembly, and slide the clip to secure it.
| 8. CONNECT UNION TO CHECK VALVE HOSE (for 6AR-FSE) |
Connect the union to check valve hose to the brake booster assembly, and slide the clip to secure it.
| 9. CONNECT UNION TO CHECK VALVE HOSE (for 2GR-FE) |
Connect the union to check valve hose to the brake booster assembly, and slide the clip to secure it.
| 10. CONNECT ENGINE WIRE (for 6AR-FSE) |
Connect the engine wire connector to the vacuum warning switch assembly.
| 11. INSTALL BRAKE MASTER CYLINDER SUB-ASSEMBLY |
| 12. INSPECT AND ADJUST BRAKE PEDAL |