POWER WINDOW CONTROL SYSTEM (for Models with Jam Protection Function on 4 Windows) > Rear Power Window RH Auto Up / Down Function does not Operate with Rear Power Window Switch RH |

| 1.READ VALUE USING INTELLIGENT TESTER (RR-DOOR MOTOR) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Body / RR-Door Motor / Data List.
Read the Data List according to the display on the intelligent tester.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| RR Door P/W Auto SW | Rear RH door power window auto switch signal / ON or OFF | ON: Rear RH power window auto switch operated OFF: Rear RH power window auto switch not operated | - |
|
| ||||
| OK | |
| 2.PERFORM INITIALIZATION (FOR REAR RH DOOR) |
Initialize the power window regulator motor assembly (for rear RH door) (Click here).
| NEXT | |
| 3.CHECK POWER WINDOW CONTROL SYSTEM (AUTO UP/DOWN FUNCTION) |
Check that the rear RH door power window moves when the auto up and down functions of the rear power window regulator switch assembly (for RH door) are operated (Click here).
|
| ||||
| OK | ||
| ||
| 4.INSPECT REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY (FOR RH DOOR) |
![]() |
Remove the rear power window regulator switch assembly (for RH door) (Click here).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 8 (AUTO) - 1 (GND) | Auto up or auto down position | Below 1 Ω |
| *a | Component without harness connected (Rear Power Window Regulator Switch Assembly (for RH Door)) |
|
| ||||
| OK | |
| 5.CHECK HARNESS AND CONNECTOR (REAR POWER WINDOW REGULATOR SWITCH (FOR RH DOOR) - WINDOW REGULATOR MOTOR (FOR REAR RH DOOR)) |
Disconnect the power window regulator motor assembly (for rear RH door) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| L4-8 (AUTO) - L2-4 (AUTO) | Always | Below 1 Ω |
| L4-8 (AUTO) - Body ground | Always | 10 kΩ or higher |
| L2-4 (AUTO) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||