Home › Vehicle Exterior › LIGHTING (EXT) › HEIGHT CONTROL SENSOR (for TMC, TMMR Made)

HEIGHT CONTROL SENSOR (for TMC, TMMR Made) > INSTALLATION

for Preparation Click here



1. INSTALL REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY


    E227547E01
  1. Install the rear height control sensor sub-assembly with the 3 nuts.

    Torque:
    Nut <A>:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }
    Nut <B>:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }

  1. Connect the connector.



2. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



3. INITIALIZE HEIGHT CONTROL SENSOR SIGNAL
for AFS (Adaptive Front-Lighting System) : (Click here)
for Automatic Headlight Beam Level Control System: (Click here)


4. ADJUST HEADLIGHT AIMING
(Click here)